Aspheric Sag Calculator
Calculate the sag and best-fit radius of an aspheric surface, supporting the conic constant and higher-order even aspheric coefficients (A2–A12), for optical design and surface profiling
🔬 Aspheric Sag Calculator
Enter the aspheric parameters to calculate the sag and best-fit radius at a specified aperture
mm
mm
—
mm⁻¹
mm⁻³
mm⁻⁵
mm⁻⁷
mm⁻⁹
mm⁻¹¹
PARAMETER GUIDE
Parameter details
Understand the physical meaning of each parameter in the aspheric equation
Clear aperture
D
Radius of curvature
R
Conic constant
k
Higher-order aspheric coefficients
A₂ ~ A₁₂
Sag
Sag (z)
Best-fit radius
R_bf
FORMULAS
Core formulas
Key formulas involved in aspheric sag calculation
COMMON MISTAKES
Common misconceptions
Common mistakes in aspheric design and testing
A₂ is defined differently from the other higher-order coefficients
Different optical manufacturers define A₂ differently. Some incorporate A₂ into the radius of curvature (i.e. R already includes the effect of A₂), while others retain it explicitly. When using Thorlabs data, A₂ is usually zero or very small because the radius of curvature has absorbed this effect. Always confirm the definition when comparing data across manufacturers.
Ignoring the sign convention for the radius of curvature
Radius-of-curvature sign conventions may differ between optics textbooks and manufacturers. In the sag formula, the sign of R directly affects the sign of the sag (convex/concave). A consistent sign convention must be maintained when substituting into the formula, otherwise the result will be completely reversed.
Best-fit radius = vertex radius of curvature
The best-fit radius R_bf is not equal to the vertex radius of curvature R. R_bf accounts for the aspheric departure over the entire aperture and usually differs significantly from R. In aspheric testing, R_bf rather than R should be used as the interferometer reference surface.
Higher-order coefficients can be truncated arbitrarily
Higher-order aspheric coefficients are not mere precision corrections; each term contributes to the surface shape in a particular radial region. Arbitrarily neglecting higher-order terms (even when numerically small) can significantly increase surface deviation in the edge region and degrade image quality.
The greater the sag, the harder it is to manufacture
Sag itself is not the only determinant of manufacturing difficulty. More critical is the aspheric departure (Δz) and its spatial frequency distribution. An element with a large sag but close to spherical may be easier to manufacture than one with a small sag but large high-frequency departure.
No higher-order terms are needed for a paraboloid with k = −1
For imaging of objects at infinity, an ideal paraboloid indeed needs only k = −1. In practice, however, aspheric mirrors often require higher-order corrections to compensate for residual aberrations of other system components, so a parabolic mirror may also have non-zero higher-order coefficients.
PRACTICAL EXAMPLES
Application examples
Typical aspheric parameters and calculation scenarios


